The storm blew through last night.  Lots of rain and wind into the high 30’s but no damage at least around here.  Today was partly cloudy with occasional rain so we couldn’t finish the exterior varnishing, but I have the dorade boxes and some wood frame screens up in the workshop where I can varnish those without threat of rain.

Two other projects:

1. Lisa gave us a couple hard drives with movies and we spent some time downloading them to our drive so we have some “rainy day” entertainment.

2. Winch maintenance.  All the winches need some work, but the big cockpit winches haven’t been overhauled down to the gears in a few years.  It’s very time consuming, detail work, but cleaning out all the old grease and crud helps the winches last longer and work better.  We got the starboard one done.  Tomorrow the port side and maybe a couple others.  Depends on the weather which is supposed to be cloudy with some rain all weekend

The gears were pretty cruddy. I did the rough clean with a toothbrush in mineral spirits and then Ann used polish for the detail clean.

The trick is remembering where all the little gears, bearings and shafts go back together. I lay them on a towel on the deck in the same configuration as they come off.

Here's the brains of the operation. No, not me - the thing in my hand. This has four pawls with little tiny springs that engage the gears and let the winch operate at two different speeds. The trick is not to let the little springs fly out over the side when you're disassembling the thing.

Back in the water!  No more climbing up and down the ladder just to go to the toilet.  Yipes.  It was fun once, some years ago, but I’m over it (as is Ann).

So…we’re back in the water just in time for the remnants of a tropical cyclone to pass over us (not Passover).  Heavy rain should hit at midnight tonight and maybe some wind, but since we’re on an inland river, maybe not too bad.  On the coast they might get over 60 knots of wind and 25+ foot seas.

We’re happy to be back in the water.  We’re snugged up tight.  I put chafe gear on all the lines and tied anything that was loose to the deck.  More tomorrow…

Here's what we're looking at for 0600 tomorrow morning.

Always great to take that crane ride back to the water. Charisma's looking good with a new coat of bottom paint and waxed and buffed topsides. (Photo credit: Lisa Danger, Orcinius)

I think "Happy, Happy, Joy, Joy" comes to mind. (Photo credit: Lisa Danger, Orcinius)

Setting up to back in the dock. (Photo credit: Lisa Danger, Orcinius)

Whew, back in - no crashing. Those of you who know Tayana know that backing in is not a trivial exercise. Especially with wind and a 1 knot river current. Many thanks to those who came to manage our lines! (Photo credit: Lisa Danger, Orcinius)

As I have written this the wind is starting to come up (2200 local time) and the barometer has dropped 15 mb since this morning!

Bring it on!  We tucked in and going to watch a movie tonight on board.  Possibly with some Scotch, Baileys and chocolate.  Yay for cyclones!

Yup, a day early.  We’re done with the “out of the water” stuff.  Ann has finished polishing the hull and the bottom paint is on.  She timed the final polishing in between squalls today polishing in the lighter areas of rain.  What a trooper!

We’re hoping to get in the water before the remains of a cyclone that’s due to hit New Zealand gets here.  Looks like it will start mid-tomorrow and go through the next day (Friday here, Thursday in the US).  For our area, heavy rain and wind into the 30’s is what’s in the forecast.  Further south though, NZ will see some 50+ knot winds.

All the new varnish on the deck looked so good Ann convinced me to completely strip all the dorade boxes. More work (strip, sand, bleach, sand, sand sand) but they are going to look great. First of four coats went on today (the picture is after stripping and bleaching, but before three rounds of progressively finer sanding).

Spraying on the paint...

Charisma is looking good with new bottom paint, and polished hull.

Yup, we’re still here working.  Got a blister on my finger from so much sanding today.  We’re now on to the maintenance coats of varnish on last year’s work.  Two coats, but first you have to sand with 320 grit, wash with detergent and then clean the whole mess. Took all day to prep the toe rail (basically all the way around the boat), the rub rail (most of the way around) and some miscellaneous wood around hatches and such.

Ann finished polishing the hull.  Two huge accomplishments.

Charisma at night on the hard.

Tomorrow we’ll go round the whole thing with paint thinner and wipe it down, then tape it in prep for two coats.

Monday the bottom paint guys are supposed to come and Wednesday the guy who puts on “prop speed” does the propeller and associated fixtures.  Did I mention I spent about five hours yesterday cleaning and polishing the prop?

OK, the fun part.  We have a lot of friends in the boatyard with us.  Tonight we had a BBQ with Bright Angel and Orcinius and along the way Kismet Dave and Sue and Andy from Spruce also showed up.  Fun to get together at the end of a work day and swap stories.

To top it off, Ann baked a pumpkin pie in honor of her late sister Beverly who passed away nine years ago today of breast cancer.  Everyone took a serious moment to honor Bev, then dug into the delicious pie Ann made complete with whipped cream (to John’s horror it was from a pressurized can, but whatever…Lisa liked it!)

You can see the remnants of the pumpkin pie in the lower left of the picture.

Some of the gang. (Missing from the picture is "Bunghole Bob". Google teak decks and bungs and you'll get the idea)

...and all's quiet in the boat yard as we wait for another exciting day working on our boats.